Brakes

Your car’s brake system is its most critical safety system and you should check it immediately if you suspect any problems. A properly operating brake system helps ensure safe vehicle control and operation under a wide variety of conditions.Brakes are a normal wear item for any car and eventually they’re going to need replacement. Avoid letting your brakes get to the “metal-to-metal” point, which usually means accelerating expensive rotor or drum replacement.

Engine Air Filter

Typical Wear and TearFilters are normal wear items that require regular checks and replacement. Factors that affect replacement intervals include:
• Mileage• Driving habits
• Driving and road conditions
• Type of filter
• Vehicle type

Symptoms
• Poor gas mileage
• Hesitation while accelerating
• Musty odor in the cabin

Automatic Transmission Fluid

Owner's manual recommendations on transmission fluid changes vary considerably and may go as high as 100,000 miles or more. For best results, have your car's transmission fluid and filter changed every two years or 24,000 miles. Always use the type of fluid specified by your car's manufacturer. This information can be found in the owner's manual or on the end of the transmission dipstick. The overwhelming majority of transmission failures are heat-related, and automatic transmission fluid breaks down rapidly when subjected to high temperatures. Driving conditions such as trailer towing, quick stops and starts, ascending and descending mountains, and wheel-spinning in slippery conditions are but a few scenarios that can devastate the life of the transmission fluid. Although changing the fluid yourself is not difficult, it's probably best left to a qualified service technician. This is also a good time to drain the transmission fluid from the torque converter, if possible. Consult your technician to see if this can be done.

Coolant (Antifreeze)

Check your owner's manual for antifreeze usage specifications. Antifreeze, when mixed at a 50/50 ratio with water, provides excellent anti-freeze, anti-boil, and anti-corrosive properties. In extremely cold environments, the ratio for standard ethylene glycol can go as high as 70% antifreeze, 30% water.As such, it's best not to mix antifreeze types unless absolutely necessary.

All coolants must be diluted with water at the proper ratios and should not be used full-strength. Full-strength antifreeze actually has a lower freeze point than when mixed with water. Generally, standard ethylene glycol type antifreeze should be changed every two years or 24,000 miles. Even though the coolant freeze protection may test OK with a hydrometer (freeze protection only drops with extreme dilution, not with age), the additives break down over time.

When changing coolant, it also presents an opportune time to replace bad cooling system hoses. Leaking, brittle, spongy, cracked, or rotted hoses should be replaced before new antifreeze is installed. Hose clamp connections should also be checked to ensure that they're secure and free from leaks.

If you decide to service your cooling system yourself, use extreme caution: Opening a hot radiator or coolant reservoir/overflow tank can cause severe burns. Be sure that both the engine and cooling system are cool before you begin any heating/cooling system maintenance or repairs. Because of lower hood profiles and cramped engine quarters, it's also possible that your car may be equipped with an air bleed for the cooling system. Unless the cooling system is bled properly, air may stay trapped in the system and cause erratic temperatures, or in extreme cases, engine or cooling system damage. If you're unsure about any aspect of cooling system service, don't take a chance. Have your car looked at by a professional service technician.